Now we can cut the tape-not quite all the way, which leaves a little bit to stretch.ĭave: "I'm putting 2 inches to the outside and the rest is going inside."ĭave wraps the corner, putting only as much peel-and-stick inside the rough opening as the depth of the window. He cuts the bottom, but again not tight to the corner so he can bend the tape around.ĭave: "The corner is the weakest point-and we've crossed it twice. So we'll put another piece on we want to be able to go out over the 4 inches of foam and turn down." He works from the center out to either side, keeping the flashing tape along the inside edge of the window.ĭave: "Later on we're going to put 4 inches of foam on this house. Some tapes can stretch around corners, but Dave’s going to demonstrate with a standard, non-flexible flashing tape.ĭave: "You see there's a little piece of plastic inside, like a fishing line." I'll put a couple of nails in there to hold it in place because we will be shimming the window on this and putting a peel-and-stick membrane on it." The carpenters have to fill in the extra pieces above the window to flush things out.ĭave: "We like to install windows over a sloped sill, so we use beveled siding. The first steps in the process involve prepping the rough opening.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |